PRIMERS AND BASE COATS
#211 VAPORGUARD
100% SOLIDS, NON-SHRINK, HIGH-QUALITY, POLYMER RESIN COATING
VaporGard #211 is a 100% solids, non-shrink epoxy specifically formulated to penetrate into the smallest fissures and voids sealing the concrete, effectively reducing the amount of MVTR (moisture vapor emission rate). VaporGard #211 is to be installed to properly prepared concrete where moisture vapor drive is suspected, or been identified through approved testing methods.
Vaporgard #211 has been designed for interior use only.
PACKAGING & COLORS
Kit sizes available are 1, 5 gallons
USES / APPLICATIONS
A low viscosity primer for unstable concrete
A moisture suppression primer
ADVANTAGES
- Reduces MVTR (Moisture Vapor Transmission) by 80%
- Superior adhesion to properly prepared concrete – ASTM D7234 – Coating failed at 529 PSI
- Independent testing results available upon request
- Cost effective 100% solids formulation
- Extremely low viscosity to allow for deep penetration
- Excellent adhesion to properly prepared concrete substrates
- Low odor during application & cure-can be applied in occupied facilities
- VOC compliant with ALL U.S. regulations
DATA SHEET
LIMITATIONS
Mix ratio is by weight, DO NOT SPLIT KITS
Do not apply at less than 20 mils or 80 square feet per gallon
Do not thin this product with solvents
Do not broadcast sand into this product
Do not apply this product on moist or wet surfaces
APPLICATION INFO
Apply VaporGard #211 with a squeegee, brush, or high quality non-shed roller. Only mix the amount of product that can be properly applied within 15-25 minutes. Due to the lower viscosity of VaporGard #211 make sure the entire surface has been coated, and dry spots will need to be re- rolled leaving a glass-like finish.
Once thoroughly mixed this product should be placed on the surface and NOT LEFT IN THE MIXING BUCKET.
SURFACE PREPARATION – Apply VaporGard #211 only to clean and sound substrates. Mechanical preparation by means of shot-blasting or diamond grinding to an ICRI CSP 2/3 is recommended (see ICRI Guideline No. 03732 for additional details).
GET A FREE QUOTE
The experts at Thermal-Chem can provide you with expert advice and free quotes for your specific project. Call or email now.